65MM X 3MM Plow Bolt This is a weld on

This is a weld on mount for the vs450 or vs500 pin on vertical shroud

It fits on a 1-1/4" thick excavator bucket lip

Use a p160 pin with this tooth

Without this protection your base edge will scallop out over time

The Customer can do any final tooling such as adding grease fittings or welding on tabs or flags as may be needed

65MM X 3MM Plow Bolt This is a weld onThis steel bucket pin shim is for a pin with an outer diameter of 65 mm. It is 3 mm thick with an OD of 130 mm. Perfect for when you have space between your bucket ears and your machines hook up. Too much of a gap will cause your Bucket to wobble or chatter around on your machine causing wear and tear on your pins and bushings. A bucket pin shim will work just fine if it is a little larger than the Outer Diameter of your pin but not if it is smaller